Murr IO link, zeroing Magnetic sensor MSA213K

[jakesheehan]

I have a murr IMPACT67 Pro E DIO8 IOL8 M12L 5P and a Magnetic sensor MSA213K. connected to a L18.
encoder is connected to port 0 and I am getting values back.

the msg instruction is faulting with a class or instance not supported.


attached are the error/msg setup, notes on setup, what I'm sending.

thanks.

 

[jakesheehan]

missed the "upload" button.

 

[dmroeder]

You need to use 4c and 83 instead of 76 and 131 (notice in Logix, it says hex)

 

[jakesheehan]

You need to use 4c and 83 instead of 76 and 131 (notice in Logix, it says hex)

yep changed it after sending, also had to enable opcUA in the io link master.

still no luck.

error test Unsupported service requested.

thanks though

 

[dmroeder]

Have you tried with instance 1, attribute blank? Just a guess.

 

[jakesheehan]

Have you tried with instance 1, attribute blank? Just a guess.

errored
embedded service resulted in error