desa
Member
Hello, I have an MVI56-MNET module, which is installed together with EN2TR, with a subnet of ~10, all instructions have been added to the project, the MNET module has been given a subnet of ~20, which is connected in Stratix. But through the prosoft Builder program I cannot reach the MNET module and in the diagnostic overview I do not see the device, although I see its IP address on the network. My module has 1 port for ethernet, and one port for Cfg. Is this module configured only via the Cfg port or can it be configured remotely via ethernet?
Thanks for answers.
Thanks for answers.