Baker in Virginia
Member
Good Morning ,
We are going to need to change a gearbox that as a MPL-B540K-MJ24AA connected to it. The gearbox is 19.5 : 1. The problem is that the gearbox to replace it , comes only 18.5 : 1 or 21.1 :1 . Wouldn't that cause a problem since the motor and encoder is turning at a known speed , and the output is turning at a different speed ? If so , how would I adjust for the difference ? I imagine I would adjust for the difference in Axis Properties, correct ?
I am using Kinetix 6000 with a Controllogix PLC .
Thanks so much in advance
We are going to need to change a gearbox that as a MPL-B540K-MJ24AA connected to it. The gearbox is 19.5 : 1. The problem is that the gearbox to replace it , comes only 18.5 : 1 or 21.1 :1 . Wouldn't that cause a problem since the motor and encoder is turning at a known speed , and the output is turning at a different speed ? If so , how would I adjust for the difference ? I imagine I would adjust for the difference in Axis Properties, correct ?
I am using Kinetix 6000 with a Controllogix PLC .
Thanks so much in advance