Jasondelane
Lifetime Supporting Member
Hows it going everyone. Who's ready to rub their heads and groan at the new guy? Everyone? Ok good
I've got a 1756-L72 Revision 19.013 with a program already running on it.
I've got all versions of Studio 5000 installed, but have not installed any RSLogix 5000 versions to VMWare yet.
I've read the manual, and a few forum posts, and from what I can tell, I should be able to go online with the controller with any version of Studio 5000. I have a copy of the program that is running right now, but I do not want to open it with any version of Studio 5000 until I'm sure that no unintended changes will be made to the program.
My questions are:
1. If I start a new project in version 24 of Studio 5000, and attempt to go online with the Revision 19.013 controller, what should I expect to happen. Will the ladder logic be loaded that is currently running if I don't load the project file first?
2. I'm expecting that the only way that the firmware would change in the controller is by using ControlFLASH.
3. If I load the project file into Studio 5000 version 20 or higher, what changes would be made to the file?
Thanks Everyone
I've got a 1756-L72 Revision 19.013 with a program already running on it.
I've got all versions of Studio 5000 installed, but have not installed any RSLogix 5000 versions to VMWare yet.
I've read the manual, and a few forum posts, and from what I can tell, I should be able to go online with the controller with any version of Studio 5000. I have a copy of the program that is running right now, but I do not want to open it with any version of Studio 5000 until I'm sure that no unintended changes will be made to the program.
My questions are:
1. If I start a new project in version 24 of Studio 5000, and attempt to go online with the Revision 19.013 controller, what should I expect to happen. Will the ladder logic be loaded that is currently running if I don't load the project file first?
2. I'm expecting that the only way that the firmware would change in the controller is by using ControlFLASH.
3. If I load the project file into Studio 5000 version 20 or higher, what changes would be made to the file?
Thanks Everyone