Vaitheeswaran
Member
Hello,
I am using Trimble 2000 GPS, I had been trying to take the Latitude and Longitude data in my controller and SCADA. I took position data from GLL package using Functional Block Diagram(Isagraf Software). But I need to show the data in SCADA(Wonderware Intouch). The GLL package data will be like "$GPGLL,3723.2475,N,12158.3416,W,161229.487,A,A*41" this. Here i need to take both 3723.2475,N and 12158.3416,W through modbus address in SCADA. I need to know what's the datatype of the values 3723.2475 and 12158.3416, is it ASCII or Decimal. When i tried to get these values in Wonderware Intouch it's showing a complete different value. If these data's are ASCII could you please tell me if Wonderware intouch can read/get ASCII values?
Thanks and Regards,
Vaithees
India.
I am using Trimble 2000 GPS, I had been trying to take the Latitude and Longitude data in my controller and SCADA. I took position data from GLL package using Functional Block Diagram(Isagraf Software). But I need to show the data in SCADA(Wonderware Intouch). The GLL package data will be like "$GPGLL,3723.2475,N,12158.3416,W,161229.487,A,A*41" this. Here i need to take both 3723.2475,N and 12158.3416,W through modbus address in SCADA. I need to know what's the datatype of the values 3723.2475 and 12158.3416, is it ASCII or Decimal. When i tried to get these values in Wonderware Intouch it's showing a complete different value. If these data's are ASCII could you please tell me if Wonderware intouch can read/get ASCII values?
Thanks and Regards,
Vaithees
India.