NSK megatorque motor

harrydeharry

Member
H
Join Date
May 2008
Location
Delhi
Posts
237
I am facing a different problem with the drive when I change the home position by AZ and check with TP5 it says current position is 0 but when I do the homing the position shift automatically and it goes to other position and their it shows the axis position at 0, what could be the problem
Thanks in advance
Harry
 

Similar Topics

H
nsk megatorque motor
Dear All, I need some software to genrate the back up of SNK ESA megatorelque drive on my computer. I have heard some NSK teach tool is the...
Replies
9
Views
4,631
Rockhead
Rockhead
D
Stop AC motor at specific positions
Hope you are doing well. Currently, I am involed in a revamping project. It requires to stop a mixer at specific postion. For the detail, this...
Replies
1
Views
3
parky
P
JeffKiper
Single phase motor starter and overload
I'm looking for how others do it. I need to start a 1 phase motor. I have always used a regular 3 phase Motor Protected Circuit Breaker and looped...
Replies
9
Views
228
I_Automation
I_Automation
P
🔧🔌 New to Motor World! Need some guidance. 🔌🔧
I've got this 3-phase 575V motor that we're controlling with a VFD (Variable Frequency Drive), which has been quite the learning curve in itself...
Replies
10
Views
309
tripstuf2
T
S
IE5 ABB motor and VFD
Hello, It is mandatory to use VFD IF i use IE5 electrical motor? What happens If connect it directly as delta without VFD? Please look at motor...
Replies
1
Views
162
kamenges
K
Back
Top Bottom