Hi!
I am having a problem with the C200HE. It has a SRM21-V1 communication module with SRT1-ID08 remote input module. I think the protocol used is CompoBus/S.
I uploaded the program using CX-Programmer and did some changes. After that I downloaded it again. I found out the IO table was missing. So I have created the IO table.
The program addresses for the remote IO are from 108.00 to 108.07 . But now any change to the inputs of remote IO SRT1-ID08 are not seen in the program when online.
(I do not have "Rack/Slot start addresses" in options of IO table. ) I have attached some pics of the project.
How can I map these memory bits to the remote IO again ?
Thank you in advance.
I am having a problem with the C200HE. It has a SRM21-V1 communication module with SRT1-ID08 remote input module. I think the protocol used is CompoBus/S.
I uploaded the program using CX-Programmer and did some changes. After that I downloaded it again. I found out the IO table was missing. So I have created the IO table.
The program addresses for the remote IO are from 108.00 to 108.07 . But now any change to the inputs of remote IO SRT1-ID08 are not seen in the program when online.
(I do not have "Rack/Slot start addresses" in options of IO table. ) I have attached some pics of the project.
How can I map these memory bits to the remote IO again ?
Thank you in advance.
Last edited: