Dear all,
I altered a program with a new Analogue input card.
So far so good everything is working fine only that an input that used to work fine and got nothing to do with the analogue values, doesn't want to switch.
Hardware wise its switching ( LED on card goes ON/OFF) but in the watch window that specific input 6.15 doesn't change state . Neighboring input 6.11 is working fine.
Any Ideas
Regards
Andy
I altered a program with a new Analogue input card.
So far so good everything is working fine only that an input that used to work fine and got nothing to do with the analogue values, doesn't want to switch.
Hardware wise its switching ( LED on card goes ON/OFF) but in the watch window that specific input 6.15 doesn't change state . Neighboring input 6.11 is working fine.
Any Ideas
Regards
Andy