PotatoBrado
Member
Howdy,
I’m working with an Omron CJ2M PLC and am hoping you can point me in the right direction…
I’m trying to get the NS10 HMI/PT to talk to the PLC over ethernet and I’m not sure how to bridge the gap.
Programs are loaded, IP addresses set, error messages/lights gone, can ping both HMI and PLC.
The HMI screen is stuck on “Connecting…”
And that’s where I’m at. Any Idea for my next move?
Thanks,
Potato
I’m working with an Omron CJ2M PLC and am hoping you can point me in the right direction…
I’m trying to get the NS10 HMI/PT to talk to the PLC over ethernet and I’m not sure how to bridge the gap.
Programs are loaded, IP addresses set, error messages/lights gone, can ping both HMI and PLC.
The HMI screen is stuck on “Connecting…”
And that’s where I’m at. Any Idea for my next move?
Thanks,
Potato