Omron EJ1n modular controller

Terry Boblitt

Member
T
Join Date
Jan 2006
Location
Willisburg, Ky.
Posts
119
I have 12 of theses in 2 racks connected by Devicenet to a Compaq logic processor. One of then isn't acting like the others. I'm getting more deviation. I've been reading the manual---you have to set theses up if one is replaced--right? It's not as simple as setting the dip switch and the node address? I have one of these at the front of the rack EJ1N-HFUB-DRT.

Any help & advice is appreciated.
Thanks Terry
 

Similar Topics

D
OMRON CJ1M PLC to EJ1N-TC4 communication
Hello all, I would like to ask how to transfer the temperature reading of OMRON EJ1N temperature controller to the data memory (ex. D100) of...
Replies
1
Views
4,617
RoTaTech
R
BobB
SMS messaging from an Omron CJ2M-CPU31
Has anyone done SMS messaging from an Omron CJ2J-CPU31 PLC? If so could you help please. Omron here in Oz have not had any experience doing this...
Replies
5
Views
174
BobB
BobB
I
omron cj2m with scada comunication
I have an old plc in the system I have, moxa nport was used to communicate with scada, I want to replace the plc with cj2m cpu33 and eliminate...
Replies
1
Views
64
IO_Rack
IO_Rack
J
Omron CJ2m cpu33 - reading codes
Hi all, i have 8 CJ2m plc units that show different numbers on the plc display and i am stuck on reading the info. my unit has an ip address of...
Replies
3
Views
110
chelton
C
K
Siemens S7-1200 with Omron M1 - Modbus RTU
Hi all, Currently having trouble getting a speed reference to write over modbus to an Omron M1... I can successfully write a run command and...
Replies
6
Views
261
KalvMavin
K
Back
Top Bottom