Hi all,
I have a bit of a mental block in regards to some programming i need to do....
The factory cuts large sheets via a saw into various size stacks of melamine boards that then get loaded onto one of three storage conveyors. The packs of board travel down the conveyors then are transferred by a trolley setup to one of 7 stations that then edge them / bore them ect. The issue i have is that they wish (via a scada) to change which of the seven stations gets priority over the others, when their type/shape board is present on the storage Conveyors.
How would i do this elegantly?? without lots of if x is greater than y then do z code??
any ideas would be much appreciated
Simon
I have a bit of a mental block in regards to some programming i need to do....
The factory cuts large sheets via a saw into various size stacks of melamine boards that then get loaded onto one of three storage conveyors. The packs of board travel down the conveyors then are transferred by a trolley setup to one of 7 stations that then edge them / bore them ect. The issue i have is that they wish (via a scada) to change which of the seven stations gets priority over the others, when their type/shape board is present on the storage Conveyors.
How would i do this elegantly?? without lots of if x is greater than y then do z code??
any ideas would be much appreciated
Simon