Hi,
Have a job where the client spec calls for their own style of wire numbering. They want unique identification each end of the wire using the 'source/destination' information...
eg - Label at one end should read "K1-13/TB02-01" and the other end should read "TB02-01/K1-13"
I've used the replaceable parameters (%S%F%N) etc. but not sure if this is achievable without some involved customisation?!
Any ideas?
Regards,
Rob
Have a job where the client spec calls for their own style of wire numbering. They want unique identification each end of the wire using the 'source/destination' information...
eg - Label at one end should read "K1-13/TB02-01" and the other end should read "TB02-01/K1-13"
I've used the replaceable parameters (%S%F%N) etc. but not sure if this is achievable without some involved customisation?!
Any ideas?
Regards,
Rob