OT: Keyway Width / Depth Inspection

alive15

Member
A
Join Date
Oct 2015
Location
Montgomery, AL
Posts
724
Good morning guys, I'm searching to find a product that can inspect the width and depth of a keyway on the end of shaft. Width is 1/4" ±.001 tolerance and depth is .145" ± .005. My caveat is a budget of $6k just for the gaging device. Was not sure if there was a good camera that could achieve this tolerance for this price however. I'm currently looking at Keyence & Cognex products, but would be grateful if anyone could share experiences with specific models/product lines. Thanks!
 

Similar Topics

K
Kinetix configuration fault Command Notch Filter Width Undefined attribute
Kindly, we have the following configuration fault on a Kinetix 5700 axis. It only appears when we go online on the Plc. We are just starting the...
Replies
2
Views
116
Kataeb
K
dvanovec
Bandwidth and Integrator Bandwidth
Hi guys, would someone please help me to understand and explain what are settings bandwidth and integrator bandwidth do with my servo in...
Replies
2
Views
137
dvanovec
dvanovec
V
Schneider BMXDDO3202K digital output pulse width
I am monitoring two BMXDDO3202K digital outputs for their behaviour, they are each for opening and closing, and so the on time affects how far the...
Replies
1
Views
293
Lare
L
C
Out of Bandwidth Connection
Hello! I am expanding a plant and IÂ’ll have to add 27 powerflex 525 that communicate through Ethernet/IP. IÂ’ve already added 12 of them. The...
Replies
9
Views
3,754
Jim3846
J
J
AB Read vs Write bandwidth
I am working on a CLX that has to message tag values to and from a DH+ network that is somewhat congested. It is in the works to remove nodes from...
Replies
3
Views
1,464
Peter Nachtwey
Peter Nachtwey
Back
Top Bottom