Freak
Member
Hi All - I know that this has been covered off previously but I can't find the right solution.
I have a:
PanelView 550 2711-T5A2L1X 4.41
Connected to a:
DH485 Link Coupler 1747-AIC B
Connected to a:
AIC+ 1761-Net-AIC B
Connected to a SLC5/04 1747-L542B
I need to update the PanelView but I am unable to see it in RSLinx. I am running RSLinx Lite Ver 3.80. I have tried to use a 1747-UIC Ver 1.3 but I cannot get any lights to go on the DH485 Comms. I used a straight through ethernet cable to connect directly to the 485 port on the screen.
I then tried to use a USB to serial converter 9300-USBS Rev 3.0 and connected to the 485 port on the AIC+. This had written in texta use a PIC driver, which is obviously no good. Tried to set up a DF1 driver manually, this was unsuccessful.
Next option I tried was to set an older version of Linx on my VM but as I am only using the windows version I can't get pass through to a real serial port (on my docking station).
So I am after new ideas.
Cheers
I have a:
PanelView 550 2711-T5A2L1X 4.41
Connected to a:
DH485 Link Coupler 1747-AIC B
Connected to a:
AIC+ 1761-Net-AIC B
Connected to a SLC5/04 1747-L542B
I need to update the PanelView but I am unable to see it in RSLinx. I am running RSLinx Lite Ver 3.80. I have tried to use a 1747-UIC Ver 1.3 but I cannot get any lights to go on the DH485 Comms. I used a straight through ethernet cable to connect directly to the 485 port on the screen.
I then tried to use a USB to serial converter 9300-USBS Rev 3.0 and connected to the 485 port on the AIC+. This had written in texta use a PIC driver, which is obviously no good. Tried to set up a DF1 driver manually, this was unsuccessful.
Next option I tried was to set an older version of Linx on my VM but as I am only using the windows version I can't get pass through to a real serial port (on my docking station).
So I am after new ideas.
Cheers