PanelView 1000 error's

seanscaggs

Member
S
Join Date
Aug 2013
Location
Michigan
Posts
1
I have a panelView 1000 cat# 2711-T10C20. I am getting the following error messages on screen: COMM fault 645, COMM driver 637 and 634. IT checked ethernet communication, I had installed a new memory card, after sorter starts to run about 10 minutes in operation these are the faults that I am getting and have to reset PanelView. Any recomendations?

Sean
 

Similar Topics

M
Fatal Error - Panelview Plus 1000
Hey there. I have a PV Plus 1000 FW: 5.10.16.09 I cannot change the communication setup to direct my device shortcut to a different PLC. This...
Replies
5
Views
5,320
mhertwig
M
D
PanelView 1000 Error State
I have a PanelView 1000 and am using Panelbuilder 32 for programming. I just downloaded a program with a few changes to an existing program and am...
Replies
6
Views
1,649
DGrp
D
Y
Panelview plus 1000: fatal application error
Hello guys, I have a panelview plus 1000 in which I have downloaded a .mer application but this message always appear :"Fatal Application Error...
Replies
5
Views
9,986
srgiunta1
S
D
PanelView 1000 Error 460?
Anyone have Error 460 on PanelView 1000 2711-K10C8X before? Fault occured. Error = 460.
Replies
0
Views
2,655
dono32ca
D
H
Panelview +1000 Out of Memory error
Has anybody seen this error message occur before on a Panelview +1000 touchscreen HMI? "Out of Memory" My customer says sometimes when the...
Replies
2
Views
2,874
James Mcquade
J
Back
Top Bottom