Hector Parica
Member
Hi,
I hope everyone is well.
I'm currently having a problem connecting to PanelView 1000 which was configured using PanelBuilder32 software. I want to "Upload an application from a PanelView Terminal" using RS232 cable but everytime I configure RSLinx this error always appear "Failed to find the baud and parity! Check all cables and switch settings!"
I already tried to change the Baud Rate to all available Parity value from 110 to 115200., test my RS232 cable to other devices and its good but the same problem still exists.
Kindly advise.
Thanks
Regards,
Hector
I hope everyone is well.
I'm currently having a problem connecting to PanelView 1000 which was configured using PanelBuilder32 software. I want to "Upload an application from a PanelView Terminal" using RS232 cable but everytime I configure RSLinx this error always appear "Failed to find the baud and parity! Check all cables and switch settings!"
I already tried to change the Baud Rate to all available Parity value from 110 to 115200., test my RS232 cable to other devices and its good but the same problem still exists.
Kindly advise.
Thanks
Regards,
Hector