Panelview 900 Password Screen Access

[Secpcb]

I don't have a lot of experience programming old Panelviews, I do have Panelbuider32 v3.83.01 (Build 7) & a mono PV900 with keypad (2711-K9A5). I am building a new application, not trying to get into a protected existing project of someone else's.

I want to restrict access to 2 screens with a password required (MY password, for my use only!) but can't find where to put the password requirement. I have searched and a few posts talk about a Security tab under Objects - but I don't have it. Other posts mention a Security line under Application Settings in the application window, but it doesn't exist either. And on the Application Setting pop-up none of the tabs have any Security items on them.

Is it possible to restrict access to screens on a PV900?

 

[Mickey]

The PanelView's firmware has to be at least 4.00 or greater to support security.

Take a look at yours.

 

[Secpcb]

Mickey,

Thanks, that rules that out - this is a Rev2 PV900.

Just going to have to leave my items out & change online through RSL500.