Greyghost11
Member
Hello to all, first I want to say that I know nothing about plcs I leave it to the properly trained! I am a residental and commercial electricion and have been donating time to help my local volunteer fire department with station upgrades. My question is can the pico be used to control a mass notification siren? They have 2 of 1760s that where given to them. They are wanting to replace there old non working control unit.
The programming would need to be:
I1- on for 3 min then off
I2- on for 30 seconds off for 10 on for 30 sec off for 10 on for 30 then off
I3- on while the input is active off when not
I have played with it some and can't seem to get it correct.
Thanks for any help
Tom
The programming would need to be:
I1- on for 3 min then off
I2- on for 30 seconds off for 10 on for 30 sec off for 10 on for 30 then off
I3- on while the input is active off when not
I have played with it some and can't seem to get it correct.
Thanks for any help
Tom