DUNK
Member
Anyone have the pinout for an Allen Bradley 2090-UXNFBMP servo feedback cable with the motor connector? I have looked all over AB and I cant find anything on it.
Pinout for 2090-uxnfbmp feedback cable
- Thread starter DUNK
- Start date
Look up publication 2094-um001, it is the Kinetix 6000 Multi-axis Servo Drive Users Manual.
Page 104 and 105,
ah here you go AB's website can be a pain at times
http://literature.rockwellautomation.com/idc/groups/literature/documents/um/2094-um001_-en-p.pdf
It is a 12MB file so it may take a bit
Hope this helps
Page 104 and 105,
ah here you go AB's website can be a pain at times
http://literature.rockwellautomation.com/idc/groups/literature/documents/um/2094-um001_-en-p.pdf
It is a 12MB file so it may take a bit
Hope this helps
Similar Topics
I am trying to find a pinout for the cable mentioned above. Unfortunately, the manuals only reference 2090-XXNFMP-Sxx and I need "UX".
We are...
Hello guys,
I am trying to control a ATV12 via Modbus Poll software. I need the connection diagram for Altivar Modbus RJ45 port to DB9 port.
Thank you
Hello All
I have a modbus tcp device(Julabo magio) with an DB9 pin assignment. Pin3=B and Pin8=A. I would like to connect it on the secondary...
im tring to find out if i have a bad power supply for my panelview 1000 plus. does anyone have the pinout for the 10 pin connector on the...
Anyone happen to know the pinout on the RJ12 side of a GE HHM cable?
It's just a serial 3-wire and I know the DB-9 side.
Thanks.