We have AB 5/01 Processor.
We are detecting part with Cognex Scanner (camera).
We need your PLC Programming help!
We have "J" shaped parts magazine with index cylinder.
At mid-bottom section, Cognex scanner scans the part for the wrinkle and alerts to PLC either good or bad.
When I get "bad" part signal from camera, I:1/8, I need to count 3 cycles before I can reject. Another words, reject bin is located at 3rd cycled index position from scanning area.
Anyone can help?
We are detecting part with Cognex Scanner (camera).
We need your PLC Programming help!
We have "J" shaped parts magazine with index cylinder.
At mid-bottom section, Cognex scanner scans the part for the wrinkle and alerts to PLC either good or bad.
When I get "bad" part signal from camera, I:1/8, I need to count 3 cycles before I can reject. Another words, reject bin is located at 3rd cycled index position from scanning area.
Anyone can help?