Can't perform online edit on a PLC5. My problem is similar to this thread: [FONT="]http://www.plctalk.net/qanda/showthread.php?t=61189
In the Processor Online Status toolbar, it says "Edits Active". However, I looked through the program and did not see any pending edits. Looked at the Status register as suggested by the above thread and noticed status bit S:1/11 is 0. So I have a different issue.
Performed some tests on a test bench PLC and noticed that status bit S:1/6 changes to 1 when "Test Edits" is executed and changes back to 0 the edit is assembled or untested.
Went back online with the questioned PLC and noticed status S:1/6 is 1. Guessing I just need to change S:1/6 to 0. May have to do this offline and download. I am on the right track?
Thanks in advance
[/FONT]
In the Processor Online Status toolbar, it says "Edits Active". However, I looked through the program and did not see any pending edits. Looked at the Status register as suggested by the above thread and noticed status bit S:1/11 is 0. So I have a different issue.
Performed some tests on a test bench PLC and noticed that status bit S:1/6 changes to 1 when "Test Edits" is executed and changes back to 0 the edit is assembled or untested.
Went back online with the questioned PLC and noticed status S:1/6 is 1. Guessing I just need to change S:1/6 to 0. May have to do this offline and download. I am on the right track?
Thanks in advance
[/FONT]