I was wondering what my options are as far as printing say a "test pass" off a connected component graphic terminal (2711R-T7T).
I will be connecting this to a Slc-5/05 Through an Ethernet switch and I would like to start a process, go through about 10 steps and if it passes then print a certain screen with data on it.
I have read on the panelview (factory talk software) this is possible just not sure how to go about this or if it can be done?
I would like to do this through ethernet switch to the printer but if I can trigger the USB or any other option that will be fine also.
Thanks in Advance!
I will be connecting this to a Slc-5/05 Through an Ethernet switch and I would like to start a process, go through about 10 steps and if it passes then print a certain screen with data on it.
I have read on the panelview (factory talk software) this is possible just not sure how to go about this or if it can be done?
I would like to do this through ethernet switch to the printer but if I can trigger the USB or any other option that will be fine also.
Thanks in Advance!