Ok guys i was looking to see if anyone has any insight to what could be my problem:
what i have as a working PanelView1200(tested with a loaded program and connected to a working 5/40 the the other part of the program)
and i have a working 5/15 (but have never tested it with the panelview)
but my problem is that i am working adding a panel view to an old program. I have tried to do block transfer writes but the panelview is telling me that is not connected.. I did try assigning it as a rack and made sure my block transfers where listed in the panelview. I truly believe its something wrong with my settings in the PLC, I am not sure if i am assigning it properly as a rack(i think though) could someone out there be able to tell my what I/O setting i should use to make this all work? anything will help
what i have as a working PanelView1200(tested with a loaded program and connected to a working 5/40 the the other part of the program)
and i have a working 5/15 (but have never tested it with the panelview)
but my problem is that i am working adding a panel view to an old program. I have tried to do block transfer writes but the panelview is telling me that is not connected.. I did try assigning it as a rack and made sure my block transfers where listed in the panelview. I truly believe its something wrong with my settings in the PLC, I am not sure if i am assigning it properly as a rack(i think though) could someone out there be able to tell my what I/O setting i should use to make this all work? anything will help