We are trying to setup remote PLC's (Compactlogix) to talk through the ICX35. I was able to configure the ICX35 and get it on the cellular network, but not we want to connect the PLC's together and to our SCADA machine. The customer does not want to pay the ProSoft connect annual fee, so we are trying to configure firewall routers (either Sonicwall or FortiNet) to achieve this. What we have done in the past is used an ISP modem in bridge mode, and then used the firewall to create the VPN between the sites. I can't find anything in the ICX35 that would enable a bridge mode, so I was wondering if anyone has successfully done what I am trying do to.
ProSoft ICX35-HWC and Firewall Routing
- Thread starter jfritz8
- Start date
Similar Topics
Hi,
We have an application that has a device that goes through a reboot (appears un-graceful)
What then happens is the MVI module appears to hang...
I am working on setting up a Prosoft Datalogger model PLX51-DLplus-232. This unit will be collecting data from a SLC 5/05 on the DB9 port set to...
Hello. I am trying to use a Prosoft AN-X4 to improve the communications for a new panelview plus 7. This is going from a SLC-500 through DH+ to a...
Hi.
I'm using a Modbus ProSoft where I basically map data to a big INT array.
Example, where GX_I_63HPU is a REAL, MNETC.DATA.WriteData[200] an...
Hi everyone,
I’m trying to copy the configuration from one MVI69-MCM to another.
I am having no luck establishing serial comms with the device...