Hi,
I am new to this forum and new to Proworx 32. I am trying to program a modbus interface for modicon quantum PLC using Proworx32 to communicate to X110 Ronan Annunciator Panel.
I have downloaded and read the XMIT User Guide on how to configure the function block. However, a few things are not clear to me, such as how and when to enable the XMIT block. And how and when to enable/disable message transmission. How does the reset work in case there is an error, etc,.
If someone has a working example of Modbus programming using Proworx 32 ladder logic, please e-mail it to me.
My e-mail address is [email protected]
Thanks in advance.
I am new to this forum and new to Proworx 32. I am trying to program a modbus interface for modicon quantum PLC using Proworx32 to communicate to X110 Ronan Annunciator Panel.
I have downloaded and read the XMIT User Guide on how to configure the function block. However, a few things are not clear to me, such as how and when to enable the XMIT block. And how and when to enable/disable message transmission. How does the reset work in case there is an error, etc,.
If someone has a working example of Modbus programming using Proworx 32 ladder logic, please e-mail it to me.
My e-mail address is [email protected]
Thanks in advance.