Sliver
Member
New to Proworx32.
I am trying to configure a new project.
It is for an old 984-680 in a 7 slot primary rack.
I do offline setup and it accepts the 984-680 controller selection.
I try to do traffic cop but it comes up with S908 (remote I/O)
and drop 1.
I try to do an online configuration and it communicates ok(modbus)
It reads the controller properly.
I try to do the traffic cop but I get the S908/drop 1
I don't have S908 just the primary rack.
Any ideas how to configure my traffic cop?
What am I missing?
thanks,
Brian.
I am trying to configure a new project.
It is for an old 984-680 in a 7 slot primary rack.
I do offline setup and it accepts the 984-680 controller selection.
I try to do traffic cop but it comes up with S908 (remote I/O)
and drop 1.
I try to do an online configuration and it communicates ok(modbus)
It reads the controller properly.
I try to do the traffic cop but I get the S908/drop 1
I don't have S908 just the primary rack.
Any ideas how to configure my traffic cop?
What am I missing?
thanks,
Brian.