PWM to Analog

[ndzied1]

I have a Drive that outputs a PWM signal to simulate a 0-10 VDC output. When I read this in my plc the signal jumps around alot. The manual suggests an RC filter circuit.

The recommended circuit should be shown below if I uploaded the .gif right.

Does anyone make one of these in a terminal block?

 

[BobB]

You could try Phoenix. They have a lot of very good gear.

 

[Dariusch]

Hi ndzied1,

As BobB told you should try Phoenix contact.
They have just what you need. I use alot of their products and the price is ok. And the support here in DK is great.

http://www.phoenixcontact.com/com/index_1024.htm
Dariusch