f16bmathis
Member
I'm working on a 5000 project that is connected to two panel views and the PLC name is just a number. I want to change it to read something like "Blend_Cell_4". I'm pretty sure it is not connected to anything else, looking at the program.
Would this mess up anything?
I also want to use an unused program under the main program, but re-name the program "chopper" to "Post_Sifter" and of course edit the logic the same way.
Anything I need to worry about?
Would this mess up anything?
I also want to use an unused program under the main program, but re-name the program "chopper" to "Post_Sifter" and of course edit the logic the same way.
Anything I need to worry about?