Hi,
First post, I am new to this forum. I tried searching with no luck.
I am using an Omron PLC - CJ2M CPU32,and I am trying to get it to communicate with a Red Lion, G07 HMI screen. In crimson 3 I have set up the driver to Omron Master via FINS. The problem is that I haven't really setup a FINS network before so I am unsure of where to set the network, node and unit numbers in cx-programmer.
Can someone point me in the right direction?
First post, I am new to this forum. I tried searching with no luck.
I am using an Omron PLC - CJ2M CPU32,and I am trying to get it to communicate with a Red Lion, G07 HMI screen. In crimson 3 I have set up the driver to Omron Master via FINS. The problem is that I haven't really setup a FINS network before so I am unsure of where to set the network, node and unit numbers in cx-programmer.
Can someone point me in the right direction?