POWER_PACKED
Member
- Join Date
- Apr 2004
- Posts
- 48
Hi people - I think this is a stupied one, But I really need to know this. I ordered a cylinder and couple reed low gauss switches that comes with it. The switches that I ordered didn't come and replacement switches came instead REED switches P/N RSQ02 That are normally open with M8 male plug. The switch has only two pins! Pin 1 and Pin 3 it says on the switch wiring diagram that
Pin 1 is + and Pin 3 is -, Switching voltage is 5-125 Vac/dc. My question is, how the hell do you wire this thing!!!!! lol, Can I get signal conditioning from it? I mean Can I wire the switch to a PLC input Card?? I don't want to call the supplier and sound stupied I would rather get taught by the knowledgeable people here. Thanks a bunch.
Regards,
Y@S!
Pin 1 is + and Pin 3 is -, Switching voltage is 5-125 Vac/dc. My question is, how the hell do you wire this thing!!!!! lol, Can I get signal conditioning from it? I mean Can I wire the switch to a PLC input Card?? I don't want to call the supplier and sound stupied I would rather get taught by the knowledgeable people here. Thanks a bunch.
Regards,
Y@S!