Hello,
I have an issue with an application I am trying to implement.
We are using a PC to run as an HMI. We installed FTView ME and everything else required for it. However, when we try to run the application it doesn’t link up the tags. ( I know the '.mer' initself works because I tried it already on another computer)
I opened up the application in Studio on the same PC and noticed that it registers the PLC as a “?” Its almost as if it doesn’t have an EDS file. I did in-fact already install it for RSLinx; but as I understand it, FTView uses RSLinx Enterprise, and I don’t know how to add a ‘driver/device’ in the 'device selection tree' so it is available in FTView.
FTView version: 6.10
RSLinx Enterprise version: 5.40 (CPR9 SR 4)
RSLinx version: 2.59
Any help would be greatly appreciated as I am at a loss at this point.
I have an issue with an application I am trying to implement.
We are using a PC to run as an HMI. We installed FTView ME and everything else required for it. However, when we try to run the application it doesn’t link up the tags. ( I know the '.mer' initself works because I tried it already on another computer)
I opened up the application in Studio on the same PC and noticed that it registers the PLC as a “?” Its almost as if it doesn’t have an EDS file. I did in-fact already install it for RSLinx; but as I understand it, FTView uses RSLinx Enterprise, and I don’t know how to add a ‘driver/device’ in the 'device selection tree' so it is available in FTView.
FTView version: 6.10
RSLinx Enterprise version: 5.40 (CPR9 SR 4)
RSLinx version: 2.59
Any help would be greatly appreciated as I am at a loss at this point.