xC0MMAND0x
Member
I have an application I converted to FTSE 7.0, so far that is going fine. The programs written for in were written in RSLogix 500. I have the emulator downloaded and licensed, but I've never used it and it's very different than the 5000Emulator.
It seems I point to a PLC file, and it loads the .rss into an emulator slot. I did that for 5 different programs in 5 different slots, and set them all to RUN. As far as I can tell, I am not getting any errors in 500Emulate.
In FTSE, I go to the communications, and I don't see my Emulators under RSLinx Enterprise. I already added a virtual driver in RSLinx Classic Gateway, but I can't for the life of me see any of my emulators.
Am I missing a basic configuration step, or any ideas/thoughts/suggestions?
I did google around a bit and read some how-to guides, but can't get things working.
Thank you in advance for anything (even if you just post a link and and say, "read this dummy!"
It seems I point to a PLC file, and it loads the .rss into an emulator slot. I did that for 5 different programs in 5 different slots, and set them all to RUN. As far as I can tell, I am not getting any errors in 500Emulate.
In FTSE, I go to the communications, and I don't see my Emulators under RSLinx Enterprise. I already added a virtual driver in RSLinx Classic Gateway, but I can't for the life of me see any of my emulators.
Am I missing a basic configuration step, or any ideas/thoughts/suggestions?
I did google around a bit and read some how-to guides, but can't get things working.
Thank you in advance for anything (even if you just post a link and and say, "read this dummy!"