akosimalakas
Member
Hi guys, need help for this error.
Invalid output instruction position.
RSlogix500
Invalid output instruction position.
RSlogix500
RSLogix500
- Thread starter akosimalakas
- Start date
Mickey
Lifetime Supporting Member
The "SUB" instruction is an output instruction and must be on the right hand side of the rung. Last position.
You can't have 2 output instructions in RSLogix500 on the same rung( in series). You can branch them on the same rung (in parallel)
You can with RSLogix5000.
You can't have 2 output instructions in RSLogix500 on the same rung( in series). You can branch them on the same rung (in parallel)
You can with RSLogix5000.
Last edited:
akosimalakas
Member
OP
got it sir.
akosimalakas
Member
OP
how about sir having an error:
Operand sizes do not match
Operand sizes do not match
Mickey
Lifetime Supporting Member
drbitboy
Lifetime Supporting Member
see the other thread.
Similar Topics
So basically i have 2 queries :
1. I have a program file of S7-300 PLC which i want to migrate in RSLogix500.In short i want to convert my simatic...
So here's my situation, I have been tasked with modifying the logic to mimic a button press in the PLC. I have two identical machines however one...
Hello,
I'm new to programming. I'm using RSLogix500 to modify an existing program for a SLC500. My plan was to use one of the existing inputs...
So i have an allen bradley rack (2080-LC50-24QWB), i have it connected through ethernet.
I dont have an offline program so im trying to upload...
Hi Everyone,
I am supporting a system which runs on a SLC 500 (1747-L532). A fault has developed whereby the output state of some digital outputs...