RSLogix5000 Pass-through Descriptions and nested UDT's

Zazoo

Member
Z
Join Date
Jul 2012
Location
Maine
Posts
4
I've noticed that for nested UDT's in RSLogix5000 (v20), only the top-level description is passed through. Can this be changed so that the descriptions at each UDT level are passed through (concatenated)...?

For example, if I have the following UDT nesting: UDT1 -> UDT2 -> UDT3 -> Member1, then I would like the description for member to be "UDT1Desc UDT2Desc UDT3Desc MemberDesc" (e.g. "Laser Settings Beam Power") not "UDT1Desc MemberDesc" as it shows up now (e.g. "Laser Power")

Thank you,
Zazoo
 

Similar Topics

N
RSLogix5000 Software Install
Hi! So my problem is a little funky, I had Studio 5000 v 24 and 30 installed, but forgot to install RSLogix (which I cannot go without). Is there...
Replies
2
Views
123
NewPLCuser2024
N
R
Odd request RSLogix5000 - Send 80 character string from One PLC to another with I/O
So I had an odd request from a customer for the above. I have written the logic and tested it all in one PLC with only using 7 outputs and 7...
2
Replies
15
Views
428
drbitboy
drbitboy
B
Adding emulator PLC to existing RSLogix5000 project
Hello everyone, I have an RSLogix5000 project which is running live in the factory but I need to make some changes to the logic. I want to test...
Replies
0
Views
1,124
BlindeBandiet
B
G
RsLogix5000 GSV Variable
Good Morning Everyone, I'm looking to use the GSV instruction to get I/O fault codes for my project so I know if there's a comms issue in my E/IP...
Replies
5
Views
871
JeremyM
JeremyM
F
rslogix5000 1756 faults when going online
The machine is running production. When trying to go online with the laptop the whole machine looses communication and faults out. Drives, HMI...
Replies
13
Views
1,941
Ken Roach
Ken Roach
Back
Top Bottom