Hi,
I'm having some problems trying to communicate my laptop to a Panel View Plus 1000 via serial cable on the RSView Studio software (release version 4.0), when I go to the communications palete, and I add the driver, I choose "Serial DF1" and I configure it properly (right port, right device, right sation number, baud rate, etc), but when the program starts browsing to connect to the device, I get the following error:
DF1: Driver failed to autoconfig COM1: and therefore will not start. Please verify cable and channel settings.
I already check the cable and it is alright, I also check the port and is correct and available.
And I have used the same cable and settings to communicate to an SLC505 on the RSLinx and I've had no problems there... (this only to clarify that the settings and cable are correct)
Could you please help me?
I'm having some problems trying to communicate my laptop to a Panel View Plus 1000 via serial cable on the RSView Studio software (release version 4.0), when I go to the communications palete, and I add the driver, I choose "Serial DF1" and I configure it properly (right port, right device, right sation number, baud rate, etc), but when the program starts browsing to connect to the device, I get the following error:
DF1: Driver failed to autoconfig COM1: and therefore will not start. Please verify cable and channel settings.
I already check the cable and it is alright, I also check the port and is correct and available.
And I have used the same cable and settings to communicate to an SLC505 on the RSLinx and I've had no problems there... (this only to clarify that the settings and cable are correct)
Could you please help me?