RX7i controllers Network

adnan_hayat88

Member
A
Join Date
Apr 2013
Location
Karachi
Posts
46
I need to design an Rx7i based system in which 14 PLC`s will be communicating with a redundant HMI server. Each PLC should also be redundant(HSB configuration) i.e redundant power supply, CPU and i/o cards. The data will be shared on the HMI using fibre optic backbone.

Now I have designed Redundant controllers with redundant Genius bus Network System but I am confused regarding the above mentioned System. Any Suggestions?
 

Similar Topics

2
Rx7i modbus RTU communications issue
Hi All, I have a question would like to ask the experts: my system has two Rx7i PLCs and I'm having them communicate with an RTU (D25) via modbus...
Replies
2
Views
2,065
2Faced
2
J
Rx7i DROPOUT
I have an Rx7i that is dropping out randomly. The modules and rack have been replaced. The CRM is on one of the I/O modules (rack 1 slot 6) so...
Replies
4
Views
1,579
Jim66Stang
J
J
RX7i convert to PC-based
I have a RX7i application that I would like to "convert" (or, perhaps <port> is a better word) to ...well, something else. The code is Proficy ME...
Replies
5
Views
2,631
RussB
RussB
A
Rx7i Redundant Contrller Single Bus Network Problem
I have an Rx7i Redundant Controller having a Single Genius Bus Network i.e Each Primary and Secondary rack have one GBC. This has happened three...
Replies
1
Views
2,234
RussB
RussB
A
Rx7i Controller error 8097
One of our customers had a Rx7i redundant Controller system for their plant. Due to some power failure the Controllers power was interrupted. Now...
Replies
1
Views
4,439
RussB
RussB
Back
Top Bottom