jonno
Member
Hi Guys
I wonder if there is somebody who may be able to shed a bit of light on a problem I have, I,ll try take you through the scenario of what has happened, It,s been nearly 11 years since I have had the pleasure to work with S5,s.....
We have just come to re-insert the processor a 943b into the rack after removing it due to flooding, everything was removed pre-flood.. upon powering up the processor blew and took out the power supply with it.. these have been replaced like for like and I have managed to reload the prog into the processor, along with the processor we have a serial interface unit 6es5 308 3ua12 connected to two et100u units, the interface has a eprom card 6es5 376 0aa11 normally with the address and rack config, I,ve managed to borrow a external Lpt prommer and have com et100 v2.1 software, s5 software is v6.3...
I,ve managed to set up the config and addressing for the remote racks but when i come to blow the eprom after selecting submodule type 56 it will download so much then stop with the message faulty module handling, check module.. it normally stops around about a035 (not sure what this is) I,ve tried to download to three seperate eproms but still get the same message... Could anybody point me in the correct direction as to what the possible cause could be, or has anybody had the same problem.. ?? could it be the case of 3 bad eprom cards ?
Any help or pointers would be greatly appreciated
Thanks in adavance
Jonno
I wonder if there is somebody who may be able to shed a bit of light on a problem I have, I,ll try take you through the scenario of what has happened, It,s been nearly 11 years since I have had the pleasure to work with S5,s.....
We have just come to re-insert the processor a 943b into the rack after removing it due to flooding, everything was removed pre-flood.. upon powering up the processor blew and took out the power supply with it.. these have been replaced like for like and I have managed to reload the prog into the processor, along with the processor we have a serial interface unit 6es5 308 3ua12 connected to two et100u units, the interface has a eprom card 6es5 376 0aa11 normally with the address and rack config, I,ve managed to borrow a external Lpt prommer and have com et100 v2.1 software, s5 software is v6.3...
I,ve managed to set up the config and addressing for the remote racks but when i come to blow the eprom after selecting submodule type 56 it will download so much then stop with the message faulty module handling, check module.. it normally stops around about a035 (not sure what this is) I,ve tried to download to three seperate eproms but still get the same message... Could anybody point me in the correct direction as to what the possible cause could be, or has anybody had the same problem.. ?? could it be the case of 3 bad eprom cards ?
Any help or pointers would be greatly appreciated
Thanks in adavance
Jonno