Ghoetic
Member
Hey.
I have an S7-1200 system, which i intend to communicate with a eurotherm Epack 1ph controller via profinet.
I have installed the GSD and added the telegram modules.
Now i would like to get some input/tips/best practices for working with the device as a seperate block.
Meaning i want to make a FC or FB and be able to set remote setpoint, firing enable and then read Voltage,current, PV,SP.
Should i tag the inputs in a tag table and use these on the outputs or is there a way to have input to the FC/FB for the input/output adress. lets say inputs start at 112
Made a mockup of the examples.
And just for the record i am a very much new to the siemens ways of programming
I have an S7-1200 system, which i intend to communicate with a eurotherm Epack 1ph controller via profinet.
I have installed the GSD and added the telegram modules.
Now i would like to get some input/tips/best practices for working with the device as a seperate block.
Meaning i want to make a FC or FB and be able to set remote setpoint, firing enable and then read Voltage,current, PV,SP.
Should i tag the inputs in a tag table and use these on the outputs or is there a way to have input to the FC/FB for the input/output adress. lets say inputs start at 112
Made a mockup of the examples.
And just for the record i am a very much new to the siemens ways of programming