doannhat0507
Member
Dear all,
Now i'm communicating S7 1500 (profibus card:CP 1542-5)with altivar 630 through profibus.
Hardware confiugre is OK, i use "Profidrive standard telegram 1".
There are two options for this control:
1.Using Control word and Status word to start stop motor and this control is OK.
2.Using MC block, i got a problem at this point. When i use MC-Power to enable Axis, bit "Busy" is true but motor not run.
Can anyone help me about option 2?
Thank All.
Now i'm communicating S7 1500 (profibus card:CP 1542-5)with altivar 630 through profibus.
Hardware confiugre is OK, i use "Profidrive standard telegram 1".
There are two options for this control:
1.Using Control word and Status word to start stop motor and this control is OK.
2.Using MC block, i got a problem at this point. When i use MC-Power to enable Axis, bit "Busy" is true but motor not run.
Can anyone help me about option 2?
Thank All.