I know there are already a few Threads with similar setups but i still think i'm missing something.
I have an S7-315PN/DP with ET200M's and Danfoss FCD300 VSD's connected via the profibus.
I have installed the GSD files, setup the HW config and have used the 2 Blocks supplied by Danfoss. One block just detects connected nodes and the other is for Parameter Assignment.
Where do I use this PCA block? OB1?
After this do i make changes the the values by writing directly to the PIW address?
Thankyou in Advance
I have an S7-315PN/DP with ET200M's and Danfoss FCD300 VSD's connected via the profibus.
I have installed the GSD files, setup the HW config and have used the 2 Blocks supplied by Danfoss. One block just detects connected nodes and the other is for Parameter Assignment.
Where do I use this PCA block? OB1?
After this do i make changes the the values by writing directly to the PIW address?
Thankyou in Advance