Hi all,
I am working on a project where we are using multiple (>30) machines which are each controlled by a S7-300 PLC and equipped with a CP-343. I am trying to use just 1 simatic project, and by using the function block FB55 (IP_CONFIG) i am able to give each machine a different IP address by using software (instead of using the hardware configuration).
I was wondering if i could do the same with the MAC address of the CP-343, since some systems dont access the PLC through IP, but with ISO. Is there a way to change the MAC address via software?
Thanks, Jos....
I am working on a project where we are using multiple (>30) machines which are each controlled by a S7-300 PLC and equipped with a CP-343. I am trying to use just 1 simatic project, and by using the function block FB55 (IP_CONFIG) i am able to give each machine a different IP address by using software (instead of using the hardware configuration).
I was wondering if i could do the same with the MAC address of the CP-343, since some systems dont access the PLC through IP, but with ISO. Is there a way to change the MAC address via software?
Thanks, Jos....