shubham_khare
Member
We are having Unity Pro XL v5.0 through which Premium PLC is communicated, when I was trying to connect It is not going directly to programming mode and says the programming mode is not available and can be connected to monitoring mode. If it is connected to monitoring mode, it show the status and after 5 – 10 minutes one message says PLC reservation is just released and can be connected to programming mode. But if trying to connect to programming mode, again the same message comes and only monitoring mode is available.
Tried power recycling, downloaded with backup program, but still the same result. physical communication is normal and in monitoring mode it works and program runs fine, but not in Program mode so unable to edit. I am using CPU ethernet port for communication.
Tried power recycling, downloaded with backup program, but still the same result. physical communication is normal and in monitoring mode it works and program runs fine, but not in Program mode so unable to edit. I am using CPU ethernet port for communication.
Last edited: