So i am developing a project on v8.1 The plc is a m340
I import my tag XSY file from the control expert software succesfully.
Part of these tags is an array of a custom DDT type.
When i link my tags to graphics from this array, then it is as if the addressing does not line up at all.
For instance i link a tag motor[1].status to a colour changing graphic. but motor[2].start_number value is changing the colours. If it was just an offset i could understand and make a plan. but this seems all over the show.
If i use normal integers for instance colour_change on a specific address like %mw2 then this lines up and works
If someone has worked with this software and could give any advice it would be much appreciated.
I import my tag XSY file from the control expert software succesfully.
Part of these tags is an array of a custom DDT type.
When i link my tags to graphics from this array, then it is as if the addressing does not line up at all.
For instance i link a tag motor[1].status to a colour changing graphic. but motor[2].start_number value is changing the colours. If it was just an offset i could understand and make a plan. but this seems all over the show.
If i use normal integers for instance colour_change on a specific address like %mw2 then this lines up and works
If someone has worked with this software and could give any advice it would be much appreciated.