Seeking CNC/PMC/PLC C++ Programmer

MFGscience

Member
M
Join Date
Jan 2012
Location
Dallas, Texas
Posts
1
I'm looking for a programmer that knows alot about CNC's and PMC's to help with an APP for CNC Machine Builders.

The existing APP is written but needs to be updated and expanded to support a significant number of CNC Machine Tools and different CNC Controls.

You may qualify for an Equity position in the company.
 
Look at the top of the page there is a tab for PLC JOBS this would be better suited in there.
 

Similar Topics

R
Exploring Alternative PLC Hardware: Seeking Recommendations and Insights
Greetings All, I recently decided to start freelancing in Controls and Automation part time, most of my experience has been with Rockwell...
Replies
2
Views
155
OkiePC
OkiePC
S
Seeking Ethernet/IP Display Unit
I'd like to display 2 weights at an operator station on the plant floor. These two weights are in our L71 PLC as a DINT but I can easily convert...
Replies
4
Views
1,774
smithe213
S
krakenfan69
Seeking help with AB PLC5 to RS-485 Modbus through a Digi1 IAP
I have a PLC5/80E that I want to poll a Modbus device into using a Digi1. I have setup the message as a multihop going to the IP adress of the...
Replies
2
Views
1,437
danw
danw
I
Seeking guidance to learn PLC systems - ABB PM500
As mentioned in the title, I want to learn about PLC systems. Long story short: I had to strip out a plant room. Everything was going to the...
Replies
9
Views
2,609
Highland Controls
H
danw
seeking Foundation Fieldbus guru - troubleshoot bench test FF field transmitters
My attempt to communicate with Foundation Fieldbus transmitters with Pactware and a new, out-of-the-box Softing FF modem are a disaster - failure...
2
Replies
17
Views
5,047
danw
danw
Back
Top Bottom