Hi all,
Why do I get these jobs! We have a customer who has imported a new multi axis stacking machine. The machine is minus wiring and controls but has servo motors fitted. There is limited to no information about these servos on the name plates.
This is my first servo job too by the way.
Is it possible to match up a third party servo drive, from say Omron to the limited details available? I have only had a quick look at it but we have rpm, torque, voltage, Hz & current. I imagine there is lots more detail the servo drive will require to get this to run smoothly. Can this be done? Or am I walking up a path to no where? If it's to hard I can try and push for the replacement of the motors, but that's a long shot and I would risk losing this job to a competitor.
Thanks, NP
Why do I get these jobs! We have a customer who has imported a new multi axis stacking machine. The machine is minus wiring and controls but has servo motors fitted. There is limited to no information about these servos on the name plates.
This is my first servo job too by the way.
Is it possible to match up a third party servo drive, from say Omron to the limited details available? I have only had a quick look at it but we have rpm, torque, voltage, Hz & current. I imagine there is lots more detail the servo drive will require to get this to run smoothly. Can this be done? Or am I walking up a path to no where? If it's to hard I can try and push for the replacement of the motors, but that's a long shot and I would risk losing this job to a competitor.
Thanks, NP