Hi all,
I have two questions. First question is I want read the values from two capacitive proximity sensors to give a read out for example min level and max level. The second question is how do I trigger an alarm when these values are met. I am using siemens step 7 and a s300 plc, to control the level of water in a tank. Is it possible to have the read out initally in the step 7 software and then after display them on the WinCC scada system.
regards
Jimbo
I have two questions. First question is I want read the values from two capacitive proximity sensors to give a read out for example min level and max level. The second question is how do I trigger an alarm when these values are met. I am using siemens step 7 and a s300 plc, to control the level of water in a tank. Is it possible to have the read out initally in the step 7 software and then after display them on the WinCC scada system.
regards
Jimbo