Hi,
I'm trying to connect two drives (axis). I managed to configure one of them and it works fine, but when I add second one to Sercos ring only the first one was found (this one I configured earlier), display on second one shows 0. I disconect the first one, and then I managed to configure second one, but when I add previous one the problem comes again.
What should I do ?
Regards,
Matt
I'm trying to connect two drives (axis). I managed to configure one of them and it works fine, but when I add second one to Sercos ring only the first one was found (this one I configured earlier), display on second one shows 0. I disconect the first one, and then I managed to configure second one, but when I add previous one the problem comes again.
What should I do ?
Regards,
Matt