Hi there,
Currently I'm working with PLC Mitsubishi Q series and Servo Motor MR-J4 series.
All the system will monitoring using one PC that installed SoftGOT2000 inside PC for operation.
Currently I'm face NOISE in power line when I start SERVO ON signal to my servo system. What happen is my monitor PC will start show vibration/noise on it display.
From servo amplifier to servo motor, the distance power cable is around 50mtr, and same goes to encoder cable 50mtr..
To run the motor is no issue when I'm start to run ( but monitor PC still show the noise on it display).
The NOISE will only appear in system when SERVO ON signal is turn ON...
Power cable I'm using shield cable spec.
Any suggestion to eliminate NOISE in power line servo motor?
Currently I'm working with PLC Mitsubishi Q series and Servo Motor MR-J4 series.
All the system will monitoring using one PC that installed SoftGOT2000 inside PC for operation.
Currently I'm face NOISE in power line when I start SERVO ON signal to my servo system. What happen is my monitor PC will start show vibration/noise on it display.
From servo amplifier to servo motor, the distance power cable is around 50mtr, and same goes to encoder cable 50mtr..
To run the motor is no issue when I'm start to run ( but monitor PC still show the noise on it display).
The NOISE will only appear in system when SERVO ON signal is turn ON...
Power cable I'm using shield cable spec.
Any suggestion to eliminate NOISE in power line servo motor?