Servo Control Mode

JavaL93

Member
J
Join Date
Dec 2023
Location
Charlotte
Posts
1
Does any one know if its possible to jog a servo in control mode: torque mode(4).

Im using the SSV to get a torque limit but when i do the change from position mode to control mode i cant make it move.
 

Similar Topics

D
Melservo J5 by HMI control without PLC
Hi, I'm thinking about using commands for Melservo J5 controller via HMI without PLC. Have you guys done this kind of control configuration for...
Replies
3
Views
139
goghie
G
D
Control Servo mitsubishi using FB
Hi everyone. I try to using FB MC_MoveAbsolute, but Fb was error [1103 A value out of the range is set as a commanded position or travel...
Replies
7
Views
845
parky
P
M
Need help in explaining servo axis control in AB ControlLogix
Hello automation experts, I'm trying to learn about servo axis control in AB ControlLogix PLCs (L33ERMS). Attached is an example of a servo...
Replies
4
Views
1,076
mikas_m
M
A
Is a SERVO motor specific or any motor control can be SERVO?
Hi; Normally if someone talks about SERVO, its refer to such a motor control system in which a motor, having permanent magnet on rooter, or a DC...
Replies
11
Views
2,405
I_Automation
I_Automation
S
Motoman DX200 Servo control from PLC
Hello all, We have several Motoman DX200 robots. The servos run all day, everyday. I would like to turn the servos OFF on them after 10...
Replies
10
Views
2,495
PLCDontUQuitOnMe
P
Back
Top Bottom