Hi
Just have a quick question, I am updating HW config of a system which uses a few DI / RO and AI inside with an ET200S.
Card one uses byte 48.0 - 48,3
Card two uses byte 48.4 - 48.7
How do I add a DI and use the start address as 48.4?
The problem I am having is that I have to add a AO module. When I try to download the hardware the entire rack is not working. But when I added a new ET200s with only a PM and this card the system is working.
All way I can think of is to change the .cfg file but then in the future when somebody wants to add more cards, they would have the same problem.
Any advice would be appreciated.
Just have a quick question, I am updating HW config of a system which uses a few DI / RO and AI inside with an ET200S.
Card one uses byte 48.0 - 48,3
Card two uses byte 48.4 - 48.7
How do I add a DI and use the start address as 48.4?
The problem I am having is that I have to add a AO module. When I try to download the hardware the entire rack is not working. But when I added a new ET200s with only a PM and this card the system is working.
All way I can think of is to change the .cfg file but then in the future when somebody wants to add more cards, they would have the same problem.
Any advice would be appreciated.